ASE-Style Multiple Choice
While having a discussion, Technician A says that sag damage usually occurs when the vehicle is struck off-center. Technician B says that diamond damage usually occurs when the vehicle is struck off-center. Who is correct?
A. A only
B. B only
C. Both A and B
D. Neither A nor B
Answer: B
You might also like to view...
Which of the following best describes continuity monitoring?
a. Initiates an alarm when the current in the heat-tracing circuit is too low or too high b. Measures the temperature of the pipe with a digital controller connected to an RTD c. Monitors the current leakage from the system heating cable, power wiring, and components to ground d. Verifies that voltage is present at the end termination of a heat-tracing cable run
If an evaporator does not have to superheat refrigerant vapor, which of the following can be produced?
A) More cooling vapors B) Greater cooling capacity C) More heating vapors D) Greater warming capacity
All of the Start buttons must be connected in parallel with the auxiliary contactor and all of the Stop buttons
must be connected in series when installing _____. a. two or more pushbutton stations b. three or more pushbutton stations c. four or more pushbutton stations d. five or more pushbutton stations
Normalizing is a process of heating the steel to a specified temperature and then allowing the material to cool slowly by air, which brings the steel to a normal state.
Answer the following statement true (T) or false (F)