The instant the ignition switch is turned to the start position, ________
A) The pull in winding is energized
B) The starter motor starts to rotate before energizing the starter pinion gear
C) The hold in winding is energized
D) Both the pull in winding and the hold in winding are energized
D
You might also like to view...
If the number of units to be converted is not on a mathematical table, it can be calculated with simple _____.
a. addition or multiplication b. subtraction or division c. addition or subtraction d. multiplication or division
Alkaline batteries ____.
A. Can contain silver oxide, mercury, lithium, or cadmium and are considered hazardous waste B. Can be disposed in the regular trash C. Should be physically damaged before being put in regular trash D. Should be returned to the manufacturer or dealer to be recycled
How is diesel fuel ignited in a warm diesel engine?
A) Spark plugs B) Distributorless ignition system C) Glow plugs D) Heat of compression
Two technicians are discussing testing MAP sensors. Technician A says that voltage on a General Motors vehicle at idle should be about 1.0 volt. Technician B says MAP sensor frequency on a Ford vehicle at idle should be about 105-108 Hz. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician