Refer to the figure. Assume 2-1/2" threaded. If J=4", what is the e-e measurement of K? 
Fill in the blank(s) with the appropriate word(s).
10-1/8
You might also like to view...
A general lighting branch circuit installed in a house and protected by a 15-ampere circuit breaker may be wired with a __________ AWG copper conductor.
a. 14 b. 12 c. 10 d. Any of the above
The pressure inside a tire is 44.0 psi. The Schrader valve in valve stem is round and has a diameter of about 0.100 inches. How much force must be applied to open the valve? Round this answer to the nearest tenth
What will be an ideal response?
When a shaft has centers, the steady rest is set up:
A) With the shaft between centers, the top jaw is brought down to touch the shaft, then adjust the other two jaws B) Turning workpieces without a center and thus reducing friction. Higher speeds can be used C) By adjusting the lower jaws finger tight to the shaft while the dead center is in the shaft center hole, then adjust the top jaw D) By turning the shaft and checking for run out with a dial indicator. The jaws are set accordingly
An electrician purchases a new truck for the amount shown. He trades in an old truck and pays an amount of money in cash toward the total payment. When the loan is paid in full after one year, what will it cost in interest payments?
Fill in the blank(s) with the appropriate word(s).