Which of the following methods of installing a bearing onto a shaft would NOT be acceptable?
A. use an oxyacetylene rosebud
B. use a pneumatic press
C. use a hotplate and heat crayon
D. use an arbor press
Answer: A
Trades & Technology
You might also like to view...
The ____________ became models that inspired some companies to initiate some occupational health and safety activities.
Fill in the blank(s) with the appropriate word(s).
Trades & Technology
In the accompanying figure, the push-to-test switch is a two-circuit _______________ push-button.
Fill in the blank(s) with the appropriate word(s).
Trades & Technology
The ____ of an arc is the distance from the center to the edge of the arc.
A. radius B. diameter C. length D. area
Trades & Technology
The ripple frequency of a half-wave rectifier is
A) twice the ac input frequency B) equal to the ac input frequency C) one-half the ac input frequency D) zero
Trades & Technology