Everything that has been drawn and located must be explained.

Answer the following statement true (T) or false (F)


True

Trades & Technology

You might also like to view...

Answer the following statement(s) true (T) or false (F)

1. An implied datum is an assumed plane, axis, or point from which a dimensional measurement is made. 2. When dimensioning the location of a feature of size on a part, implied datums should be used. 3. A datum is the origin for dimensional measurements. 4. The datum feature symbol should be specified to be read from the top of a drawing. 5. Where a datum feature symbol or a datum reference frame symbol is repeated on a drawing, it is not necessary to designate them as reference.

Trades & Technology

Oil lines are typically made of copper and should be sized at a minimum ____________________ OD.

Fill in the blank(s) with the appropriate word(s).

Trades & Technology

Technician A says that crossovers are used to block certain frequencies to allow each type of speaker to perform its job better. Technician B says that a high-pass filter is used to block high-frequency sounds being sent to large woofer speakers, and a low-pass filter blocks low-frequency sounds being sent to tweeters. Who is right?

A) Technician A only B) Technician B only C) Both technicians D) Neither technician

Trades & Technology

An oblique drawing is a type of pictorial drawing that gives a two-dimensional effect.

Answer the following statement true (T) or false (F)

Trades & Technology