Bend allowance is important when ____.
A. the length of the neutral axis equals the material thickness
B. close tolerances must be held
C. thick material must be bent or formed into desired shapes
D. both b and c
E. none of the above
Answer: D
You might also like to view...
Only the fillet weld symbol may be used in combination with other symbols.
Answer the following statement true (T) or false (F)
When an idle speed balance (ISB) test is run on a DD-Series engine and one injector displays a high negative value, which of the following is the likely cause?
A. injector is compensating for a high injection rate B. injector is compensating for a low injection rate C. injector actuator is drawing excessive current flow D. injector actuator is producing excessive resistance
Typical TP sensor voltage at idle is about ________
A) 2.50 to 2.80 volts B) 1.5 to 2.8 volts C) 0.5 volt or 10% of WOT TP sensor voltage D) 13.5 to 15.0 volts
Actual elevation relative to sea level is shown on _____.