The term circular or line element is used to refer to ____.
A. cross sectional tolerance zone
B. single line tolerance zone
C. entire surface tolerance zone
D. both a and b
E. all of the above
Answer: D
You might also like to view...
Determine the area of a parallelogram with a base of 27 feet 6 inches and a height of 32 feet 3 inches.
Fill in the blank(s) with the appropriate word(s).
The list price of a computer program is $237.50 with a 10% discount off this price and a cash discount of 2%. Find the net cost of the cash purchase.
What will be an ideal response?
The ____________________ (dynamic, static) characteristics of a servomechanism relate to its steady-state behavior, and the ____________________ (dynamic, static) characteristics relate to the system when it is moving.
Fill in the blank(s) with the appropriate word(s).
For an evaporator to operate at peak efficiency, _____.
a. the fin spacing should be very wide b. all of the surface area inside the tubes must be exposed to flashing liquid c. the coil temperature should always be higher than the dew point of the air d. the subcooling of the entering refrigerant should be kept to a minimum