List the steps in sketching a fillet or radius.
What will be an ideal response?
STEP 1 Sketch the lines that represent the edge or corner.
STEP 2 Draw the arc to the required radius.
STEP 3 Draw two lines parallel to the edge line from the two points where the arc touches the straight lines.
STEP 4 Sketch a series of curved lines across the work with the same arc as the object line.
These curved lines start at one of the parallel lines and terminate at the other end.
You might also like to view...
If the unit rise is 6 inches and the unit run is always 12 inches, then the unit length is ____ inches.
a.12 b.13.42 c.15 d.18
The most frequently employed schematic symbols are those used by the National ____ Association (NEMA).
a. Electromechanical b. Electric Motor c. Electrical Manufacturers d. Electromagnetic
When the clutch engages, spring force clamps the friction disc between the flywheel and the ________
A) Release bearing B) Transmission input shaft C) Ring gear D) Pressure plate
To finish 1,800 square feet of drywall using conventional dry-powder joint compounds would require
approximately _____. a. 83 lbs b. 128 lbs c. 150 lbs d. 177 lbs