What procedure is used to estimate the steel studs and runners used?
What will be an ideal response?
The procedure used to estimate steel studs is to make a listing of each wall length, its thickness and height and then calculate the studs required.
The number of studs is calculated by determining the linear feet of wall required, dividing the length by the spacing required, adding for any openings, corners, and wall intersections; then adding waste.
The runners are calculated by finding the total linear feet of each wall, note its width, and add together wall lengths of the same width. Runners are required at the top and bottom of the studs.
You might also like to view...
What is the orientation of the center line of SO1?
Refer to Drawing Numbers E492877 R0 and E482878 R0.
Find angle y in the accompanying figure to three decimal places. All dimensions are in inches.
What will be an ideal response?
Large rooftop package AC units often use ________ sensors to help draw in fresh air to meet code requirements and to cool if temperature and humidity permit
A) Enthalpy B) Low pressure C) Economizer D) Airflow
What results from increasing rocker ratio?
A. Decrease in output travel at the pallet end of the rocker arm. B. Decrease in mechanical advantage. C. Increase the amount of pushrod travel. D. Increase the output travel at the pallet end of the rocker arm.