Most recent HVAC actuators are recalibrated after replacement by ________.
A) Using a scan tool or allow it to self-learn after being installed
B) Turning the ignition switch to the off position
C) Using a battery and jumper wires
D) None of the above
A) Using a scan tool or allow it to self-learn after being installed
You might also like to view...
The ____________________ of the soil determines how much adhesion of nutrients can take place
Fill in the blank(s) with correct word
ASME gives several recommendations for lettering. Which one among the following list is not part of those considerations?
A. The minimum lettering size is .125 mm on engineering drawings. B. All dimension numerals, notes, and other lettered information should be the same height. C. The spacing of letters in words should be such that the individual letters are uniformly spaced. D. Notes should be lettered horizontally on the sheet. E. none of the above
When testing the UJT with an ohmmeter, the UJT will appear as a circuit containing two resistors connected in series, with a(n) ____________________ connected to the junction point of the two resistors.
Fill in the blank(s) with the appropriate word(s).
On an independent rear suspension system, the right-rear tire has excessive wear on the inside edge of the tread. The most likely cause of this problem is:
A. Worn lower control arm bushings B. A failed rear sway bar link C. A worn-out right-rear strut D. Low tire pressure