You test governor cut-out pressure to be exactly at specification but governor cut-in is too low. What should you do FIRST?
A. raise to specification adjusting the governor
B. check the operation of the unloader circuit
C. replace the governor
D. replace the compressor
Answer: B
You might also like to view...
PROBLEM 2.C1 A rod consisting of n elements, each of which is homogeneous and of uniform cross section, is subjected to the loading shown. The length of element i is denoted by its cross-sectional area by modulus of elasticity by and the load applied to its right end by , the magnitude Pi of this load being assumed to be positive if is directed to the right and negative otherwise. (a) Write a computer program that can be used to determine the average normal stress in each element, the deformation of each element, and the total deformation of the rod. (b) Use this program to solve Probs. 2.20 and 2.126.
Isometric drawings are drawn at a ____ so it appears as if you are looking at one corner.
A. 30° angle B. 45° angle C. 60° angle D. 90° angle
Design an active lowpass filter with dc gain of 0.25 and a corner frequency of 500 Hz.
What will be an ideal response?
Auxiliary views are used to show the true size and shape of a surface that is not parallel to any of the six principal views.
Answer the following statement true (T) or false (F)