A rounded edge is usually specified:

A. To improve the appearance of a part
B. To reduce the chances of injury caused by a sharp edge
C. To prevent interference or chipping
D. All of the above are reasons for specifying a rounded edge


Answer: A

Trades & Technology

You might also like to view...

What is the purpose of the throttle actuator control system?

What will be an ideal response?

Trades & Technology

The most important tool for supervising a high-force cable pull is _____.

a. a crane to lift cable reels b. a sufficient amount of cable c. the correct cable lubricant d. working communications equipment

Trades & Technology

When nonmetallic device boxes that are 2-gang or more are used, the installed Type NM cable must be secured no more than __________ inches from the box.

a. 8 b. 10 c. 12 d. 18

Trades & Technology

The amount charged for the use of the borrowed money is the borrowed fee.

Answer the following statement true (T) or false (F)

Trades & Technology