When the seam weld symbol is located ____ the reference line, the dimensions can be placed on either side of the reference line.
A. on top of
B. astride
C. below
D. above
Answer: B
Trades & Technology
You might also like to view...
Neutral-to-drive and neutral-to-reverse shifts are called ________.
A) Test shifts B) Garage shifts C) Power shifts D) Gear shifts
Trades & Technology
A cable hanger elbow is used to _____.
a. suspend cables in long vertical runs b. divide a section of cable tray c. support piping d. make vertical offsets
Trades & Technology
_____________________ is the only gas that should be used to charge suspension cylinders.
Fill in the blank(s) with the appropriate word(s).
Trades & Technology
A ____ is a metal clip that will absorb the heat and keep it from damaging the component.
A. capacitor B. shield C. block D. heat sink
Trades & Technology