After a TP sensor has been tested using the min/max function on a DMM, a reading of zero volts is displayed. What does this reading indicate?
A) The TP sensor is open at one point during the test
B) The TP sensor signal is shorted to 5-volt reference
C) The TP sensor is shorted
D) Both B and C are possible
A
You might also like to view...
Lock-up torque converters use a damper assembly to dampen ________.
A) Torsional vibration B) Noise C) Spring oscillations D) Lateral force
The ratio of an object’s density to the density of water is
a. density b. specific volume c. specific gravity d. specific weight
Another technician from your company made a repair call last week to correct a problem at a local business
You have been dispatched to correct what appears to be the same problem. What should you do on arrival? a. Blame it on the other technician and tell the customer that you have had to correct his work in the past. b. Tell the customer it is a different problem and they will have to pay to have it fixed. c. Suggest that the customer replace the equipment to avoid problems in the future. d. Acknowledge the customer's concerns and apologize. Let them know you will get to the bottom of it.
Mixed format: 
(with a space between the whole number and the numerator)Fraction format: 
Reduce all fractions. In a motor alignment, the following pieces of steel are used under the base: one piece 
inch thick, one piece 
inch thick, one piece
align="middle" src="https://sciemce.com/media/4/ppg__examview__ch2__00001_res__nr019-3.jpg" border="0"> inch thick, and one piece 
inch thick. What is the total thickness of all these pieces?
Fill in the blank(s) with the appropriate word(s).