Answer the following statement(s) true (T) or false (F)
1. Plunger type voltage testers can be used to test control systems that operate on low voltage, such as 24 volt systems.
2. When deenergizing or energizing a control cabinet or motor control center module, the electrician should be dressed in flame retardant clothing while wearing safety glasses, a face shield, and hard hat.
3. Overload relays are intended to disconnect the motor from the power line in the event that the current draw becomes excessive.
4. When using an ohmmeter, make certain that the power is connected to the circuit.
5. Megohmmeters can develop voltages that range from 250 to 500,000 volts depending on the model of the meter and the range setting.
1. False
2. True
3. True
4. False
5. False
You might also like to view...
____________________ is the owner’s investment in the business, including profits as they occur
Fill in the blank(s) with the appropriate word(s).
The LIN bus voltage reads normal with the slave module disconnected, but then reads 0 volt when it is reconnected. What can be the cause?
A. The slave module has an internal short to ground. B. The circuit between the master and slave modules is open. C. The circuit between the master and the slave module is shorted to ground. D. The master module is faulty.
Which of these oils is recommended by General Motors for diesel engines, beginning in 2011?
A) Dexos 2 B) LL-01 C) Dexos 1 D) GM 6094M
Miscoding charges against an account ______________.