Two technicians are discussing a system with a 2-speed fuel pump that starts and stalls. Technician A says the fuel pump could be bad. Technician B says the fuel pump resistor could be bad. Who is correct?
A.)Tech A only
B.)Tech B only
C.)Both Tech A and Tech B
D.)Neither Tech A nor Tech B
Answer is C.)Both Tech A and Tech B (The problem can be with the fuel filter, fuel pump, ballast resistor, or fuel pressure regulator.)
You might also like to view...
A brazed joint should be cleaned with _____.
a. a grinder b. warm water c. a file d. sandpaper
Which of the following could be used to measure cam bushing bore in a cylinder block?
A. deck micrometer B. outside micrometer C. dial bore gauge D. Plastigagetm
Answer the following statement(s) true (T) or false (F)
1. All phase windings within the transformer normally have the same relative polarity. 2. Terminal markings indicate all the relationships between primary and secondary. 3. Most three-phase, dry-type distribution transformers are connected as a primary wye connection. 4. If the pattern is a delta-delta pattern, the displacement must be 60°. 5. It is only necessary to connect the similarly marked high- and low-voltage terminals if the transformers have the same voltage ratio, the same percent impedance, and the same angular displacement.
Name two methods commonly used to unload a reciprocating compressor.
What will be an ideal response?