Name and describe the method used to locate sectional views on a sheet other than where the cutting plane lines appear.
What will be an ideal response?
When necessary, locate sectional views on a sheet other than where the cutting plane lines appear. The method for doing this is called cross-reference zoning and is used to indicate the location of a section back to the viewing location on a previous page. The sectional view is located on a different page and is labeled with the sheet number and zone of the cross-reference cutting plane. ASME Y14.3 does not recommend a specific zone and page identification system. The cutting plane and sectional views should have a note correlating each between sheets.
You might also like to view...
Because of the variability of business and technician output, the shop manager needs to carefully track _______
A) Average labor costs B) Average rate reductions C) Percentage of taxes vs. payments D) Parts delivery time
The highest amount of resistance that can be read by the meter set to the 2k ohm scale is _____
A) 20000000 ohms B) 200 ohms C) 200k ohms D) 2000 ohms
Construction lines are used to transfer what from one view to the other in orthographis projection
A. surfaces B. distances C. objects
In the above figure, when the stop button is pressed, the N.O. CR contacts are ____________________ (open, closed) and the current through the armature _______________________________________ (flows through the resistor, is supplied through the motor control circuitry).
Fill in the blank(s) with the appropriate word(s).