What are the seven Conditions of Use?

What will be an ideal response?


The seven Conditions of Use are:

Size Factors (Cf)-Applied to dimension base values

Repetitive Member Factors (Cr)-Applied to size-adjusted Fb (bending stress)

Duration of Load Adjustment (Cd)-Applied to size-adjusted values

Horizontal Shear Adjustments (Ch)-Applied to Fv (horizontal shear) values

Flat Use Factors (Cfu)-Applied to size-adjusted Fb (bending stress)

Adjustments for Compression Perpendicular to Grain (Cc') (compression perpendicular) values

Wet Use Factors (Cm)-Applied to size-adjusted values

Trades & Technology

You might also like to view...

Electric power is generated by ____, which use the energy of falling water to turn a generator and produce electricity.

A. nuclear power plants B. hydroelectric generation plants C. fossil fuel powered generators D. on-site powered generators

Trades & Technology

En la Figura 1, el interruptor de presión está representado por el símbolo marcado:

a. B. b. C. c. E. d. F

Trades & Technology

For a gasket or shim, which of the following would most likely be specified by a note?

A. Hole radius B. Thickness C. Length D. Hole spacing

Trades & Technology

Refer to Figure P2.49 and assume



Use KVL and Ohm’s law to find:

a. The mesh currents ia , ib, and ic.

b. The voltage across each resistor.
Known quantities:
Schematic of the circuit shown in Figure P2.55 with resistors

Trades & Technology