The pinion gear has 10 teeth and the ring gear has 40 teeth. What is the axle ratio?

A. 4:1
B. 9:2
C. 5:1
D. 11:2


Answer: A

Trades & Technology

You might also like to view...

Which of the following sensors is used to provide suspension control module with feedback regarding vehicle cornering forces?

Trades & Technology

As eggs develop, the volume of yolk decreases relative to the volume of the

embryo. Why do you think this is so?

What will be an ideal response?

Trades & Technology

A series of 3/4" in diameter plug welds is to be made on the other side. The angle of the welds is to be 35°, the depth of each weld is to be 3/16", and the pitch is to be 6. What will this welding symbol look like?

A. A small horizontal rectangle is placed with the bottom length on the reference line. Inside the rectangle is the notation 3/4, above the rectangle is the notation 35°, to the right of the rectangle is the notation 6, and to the left of the rectangle is the notation 3/16. B. A small horizontal rectangle is placed with the bottom length on the reference line. Inside the rectangle is the notation 3/16, above the rectangle is the notation 35°, to the left of the rectangle is the notation 6, and to the right of the rectangle is the notation 3/4. C. A small horizontal rectangle is placed with the bottom length on the reference line. Inside the rectangle is the notation 3/16, above the rectangle is the notation 35°, to the right of the rectangle is the notation 6, and to the left of the rectangle is the notation 3/4. D. A small horizontal rectangle is placed with the top length on the reference line. Inside the rectangle is the notation 3/16, below the rectangle is the notation 35°, to the right of the rectangle is the notation 6, and to the left of the rectangle is the notation 3/4. E. none of the above

Trades & Technology

Define "desuperheat."

What will be an ideal response?

Trades & Technology