This is considered a theoretically exact size, location, profile, or orientation of a feature or point.
A. actual size
B. basic dimension
C. true dimension
D. none of the above
Answer: B
You might also like to view...
In closed-loop control applications it is necessary to convert some physical property into an electrical signal. The components that carry out this conversion are known as ____.
a. amplifiers b. armatures c. signal processors d. transducers
Inclusions can be grouped into two major types: linear slag inclusions and _____ inclusions.? ?
A. porosity? B. joint penetration? C. uniform? D. scattered?
Electronic assemblies often require ____ to be fabricated.
A. chassis B. frames C. shields D. panels E. all of the above
An air conditioning system has no blower speeds. When the blower motor power side wire is connected to a 12-volt power source, it begins to operate. Technician A says this means the blower motor is defective. Technician B says this means the problem could be in the control system. Who is correct??
A. ?Technician A only B. ?Technician B only C. ?Both A and B D. ?Neither A nor B