Which part of the clutch mechanism is built into the drive pulley?
A. The compressor shaft
B. The field coil
C. The rotor
D. The electro magnetic
Answer: C
You might also like to view...
The cost of manufacturing the step shaft illustrated is reduced 17% by eliminating the undercuts at the shoulders. The original cost is $9.37. Find the savings per part.
Technician A says it is impossible to accidentally deploy the air bag while working on the vehicle. Technician B says components and wires of the air bag system are usually bright yellow. Who is correct?
A. Technician A only B. Technician B only C. Both Technician A and B D. Neither Technician A nor B
A wiggler is a:
A) Spring loaded, scribe like indicator that can be trued to center by pushing on a ball near its point B) Shop term for a workpiece without clamps that has caught in a drill and is spinning around C) Device like a fishing lure that indicates approximate RPM of the drill D) Hold down device that allows the workpiece to "wiggle" until it is centered under the drill spindle
Eaton AMT electronics are protected against which of the following circuit malfunctions?
A. voltage spikes B. current overloads C. reverse voltage D. all of the above