A fed steer produces more of which of the following?

A. Edible tallow
B. Inedible tallow
C. Meat and bonemeal


Answer: B

Trades & Technology

You might also like to view...

There are two potential locations to construct an urgent care walk-in clinic to serve rural residents. The DN alternative is an option since the clinic is not a requirement; it would be a convenience for future patients. When incremental B/C analysis was applied at a discount rate of 8% per year, using the estimates summarized below, the results were: Rank by increasing total cost: DN, 1, 2 Location 1 vs. DN: B/C = 1.66 Conclusion: eliminate DN Location 2 vs.1: ?B/C = 0.50 Conclusion: select location 1


Dr. Thompson, the designated lead physician of the clinic, wanted location 2 to be selected. He has now challenged the estimates, especially the initial cost and disbenefits estimated for location 2. Besides, he calculated the B/C ratio for location 2 itself and obtained a value of 1.58, which he contends is very close to B/C = 1.66 reported for location 1, thus making the selection of location 1 a marginal decision. Answer the following ques­tions using a spreadsheet, for the group of people who must decide if and where to construct the clinic:
(a) Are the B/C ratios for the two locations cor­rect as reported?
(b) Can we select location 2 and still be econom­ically justified?
(c) How much less does location 2 have to cost initially to make it the better location?
(d) If the initial cost of location 2 can’t be changed, is it possible to increase the benefits to select location 2?
(e) Is the result the same if the disbenefits are completely neglected?

Trades & Technology

Draw the shear and moment curves for each member of the frame in Figure P5.27. Sketch the deflected shape.

Trades & Technology

What does the acronym MSDS stand for when referring to safety?

What will be an ideal response?

Trades & Technology

____ life cycle refers to the observation and examination of a building over the course of its entire life.

A. Engineering B. Environment C. Process D. Building

Trades & Technology