For a pull box housing shielded conductors carrying over 1,000V and used in an angled pull, the distance between a conductor entry and exit must be _____.
a. 24 times greater than the OD of the conductor
b. 30 times greater than the OD of the conductor
c. 36 times greater than the OD of the conductor
d. 45 times greater than the OD of the conductor
c. 36 times greater than the OD of the conductor
You might also like to view...
At 8:00 one morning you set out on a road trip. You travel 155 miles before stopping for lunch at 11:18. At 12:07 you start driving again, and travel 124 miles before stopping for gas. It takes ten minutes to buy gas, and you drive another 94 miles before stopping for the day at 4:30. What is your average speed for the whole day?
What will be an ideal response?
A four-bit R-2R ladder DAC is presented in Fig. 5.103.
 FIGURE 1.png)
Integral power steering gears use ________ for lubrication of the unit
A) Molybdenum disulfide B) Power steering fluid in the system C) Chassis grease (NLGI #2 ) D) SAE 80W-90 gear lube
Two adjacent foundation walls have lengths of 28' 6" and 42' 3". What should be the length of the diagonal measurement when these two walls are aligned perpendicular to one another? Round the answer to the nearest hundredth foot.
What will be an ideal response?