A shudder is noticeable at speeds around 40–55 mph in third or fourth gear. Technician A says the TCC solenoid may be partially blocked. Technician B says TCC oil pressure may be too high. Who is correct?

C. Both A and B
B. B only D. Neither A nor B


A. A only

Trades & Technology

You might also like to view...

All of the following represent information identified by the VIN EXCEPT:

A. serial number B. emission control label C. manufacturer D. country of origin

Trades & Technology

Two bored teenage boys are walking down the street. They see a car sitting at the curb, with

the keys in the car’s ignition. They both know better, but because of their boredom, they take the car for a joyride. Which of the factors shaping our ethical standards does this represent?

a. Family influences b. Peer influence c. Life experiences d. Situational factors e. Personal values and morals

Trades & Technology

Which of the following is the whole-person theory of handling permanent partial disability cases?

A. Requires a determination of how much the employee could have earned had the injury not occurred. B. Applied like a subtraction problem. What the worker can do after recuperating from the injury is determined and subtracted from what he or she could do before the accident. C. Based not just on what the employee earned at the time of the accident, but also on what he or she might have earned in the future. D. None of the above

Trades & Technology

Technician A says that the TP sensor signal voltage should be about 0.5 volt at idle and increase to about 2.5 volts at wide-open throttle (WOT). Technician B says that a TP sensor can be tested using a DMM (digital multimeter), DSO (digital storage oscilloscope), or scan tool. Which technician is correct?

A) Technician A only B) Technician B only C) Both technicians D) Neither technician

Trades & Technology