Two types of buildings with load-bearing CFS walls have been identified in this text: (a) CFS buildings as Type V(B) construction and (b) CFS buildings as Type II(A) construction. The distinction between the two is primarily based on the

A) corrosion protection of CFS members.
B) extent of prefabrication used in construction.
C) type of materials used in floor and roof assemblies.
D) size of CFS studs.
E) none of the above.


C) type of materials used in floor and roof assemblies.

Trades & Technology

You might also like to view...

A(n) ____________________ is used to reduce the noise level, control the plasma light, trap the sparks, eliminate most of the fume hazard, and reduce distortion.

Fill in the blank(s) with the appropriate word(s).

Trades & Technology

Before the strut cartridge can be removed from a typical MacPherson strut assembly, which operation is necessary to prevent possible personal injury?

A) The upper strut mounting bolts should be removed B) The coil spring should be compressed C) The brake caliper and/or brake hose should be removed from the housing D) The lower attaching bolts should be removed

Trades & Technology

The rolling circumference of both tires on the same axle of a four-wheel drive vehicle should be within ________

A) 0.6 in. (15 mm) B) 0.1 in. (2.5 mm) C) 1.2 in. (30 mm) D) 0.3 in. (7.6 mm)

Trades & Technology

Generally, limit switches are used as ____________________ devices to control the coil of relays and motor starters in control circuits.

Fill in the blank(s) with the appropriate word(s).

Trades & Technology