?Technician A says a transmission orifice is a bore in a passage that is larger than the connecting passages. Technician B says an orifice is used to dampen a fluid flow to prevent sudden or undue movement of a control valve. Who is correct?
A. ?A only
B. ?B only
C. ?Both A and B
D. ?Neither A nor B
Answer: B
You might also like to view...
?Of the two methods for locating the views, the ____ angle projection method is the most commonly used for welding drawings.
A. ?first B. ?second C. ?third D. ?fourth
If the original cap tube was .042 ID, the smaller replacement .040 cap tube should be_____.
a. Longer b. Shorter c. The same length d. Cut with a tubing cutter
When truing a grinding wheel, it is essential to start:
A) At the low (closest to the spindle) point on the wheel B) At the highest point on the wheel C) Wherever the wheel happens to be when you set the diamond at an approximate position for dressing D) At a point about midway between high and low
What is the purpose of the hot reactivation air stream in a desiccant wheel dehumidifier?
A) To evaporate the water running over the wheel B) To dry out the saturated desiccant C) To heat the evaporator D) To cool the condenser