Which of the following can be used to bend IMC?

a. A reamer
b. A hickey
c. A die
d. A hacksaw


b. A hickey

Trades & Technology

You might also like to view...

If a transmission has only one pressure test port, it will be for ________.

A) Line pressure B) Governor pressure C) Modulator pressure D) None of these

Trades & Technology

Which of the following statements is true?

A. Bubble-point pressure calculations are normally easier than bubble-point temperature calculations, since the pure-component vapor pressures are fixed (since the system is at constant temperature). B. When you flash a liquid by lowering the pressure isothermally, the result will always be a two-phase (liquid and vapor) system. C. If given the preference between data obtained experimentally or data obtained from a model, it is generally best to use the model data since those do not contain experimental errors. D. Azeotropes will only form for systems when they exhibit positive deviations from Raoult’s Law. E. None of the above are true.

Trades & Technology

The adult make alpaca is called a:

A. cria B. macho C. gelding D. hembra

Trades & Technology

Diagnosing a DBC-7 system is being discussed. Technician A says that the system must be depressurized before retrieving DTCs. Technician B says that thoroughly inspecting the vehicle and speed sensor harness is one of the first steps in proper diagnosis. Who is correct?

A. A only B. B only C. Both A and B D. Neither A nor B

Trades & Technology