When adjusting a finished work piece in a machine vise, use a:

A) 8 ounce ball peen hammer B) Plastic or rawhide mallet
C) 3 pound ball peen hammer D) Maul


B

Trades & Technology

You might also like to view...

The component which converts AC voltage into DC voltage in a modern alternator is the rectifier (bridge).

Answer the following statement true (T) or false (F)

Trades & Technology

Explain the binary system that computers use to store, record, and manipulate data

What will be an ideal response?

Trades & Technology

What is the lowest acceptable overvoltage category rating for an ammeter that will be used to test industrial

lighting and outdoor conductors? A) CAT I B) CAT II C) CAT III D) CAT IV

Trades & Technology

?A technician is capturing a current waveform for a load component on the positive side of a circuit. The current waveform shows higher-than-normal current flow. Which statement is true?

A. ?The windings within the component being tested may be shorted. B. ?The waveform should be captured on the negative side of the circuit due to increased current flow on the positive side of the circuit. C. ?A loose connection or other high resistance may exist within the controlling circuit. D. ?An open may exist within the load component.

Trades & Technology