When the cutting plane line has labels A on each end, then the sectional view has the related title SECTION A-A placed below the sectional view.
Answer the following statement true (T) or false (F)
True
You might also like to view...
If a fillet is shown on both sides of the joint, it is identified as a(n) ____________________ fillet weld.
Fill in the blank(s) with the appropriate word(s).
As a result of Dr. Nathaniel Ward's work, the Nathanien case was developed
Indicate whether the statement is true or false
Assume that the 0.52 percent carbon steel of Fig. 18.32 is slowly cooled to the temperature of point c, and then quenched to 450°C and held at this latter temperature for a period of a day. Describe the microstructure that one might find. Determine the percentages of the constituents.
What will be an ideal response?
What important limitation of range diagrams relating to load radiuses must operators take into account when consulting them?
a. The diagram does not show boom deflections under load.
b. Load radiuses shown on the diagram don’t relate to boom configuration.
c. Load radii as shown reflect gross capacities before any deductions.
d. The diagram pertains to net loads at the indicated load radiuses.
