DAC methods include

A) binary-weighted-input. B) R/2R ladder.
C) successive approximation. D) A and B above.


D

Trades & Technology

You might also like to view...

Explain why low-slope roof components (membrane, cover board, insulation, adhesives, and fasteners) must be obtained from the same manufacturer.

What will be an ideal response?

Trades & Technology

Why can pipe be a challenge to cut??

What will be an ideal response?

Trades & Technology

If a heavy duty starter motor appears to spin when energized but the engine does not turn, which of the following could be at fault?

A. worn pinion gear B. stripped flywheel ring gear C. defective starter drive assembly D. all of the above

Trades & Technology

Graph the magnitude of the CTFT of x(t) = 8 rect(3t). This signal is not bandlimited so it cannot be sampled adequately to exactly reconstruct the signal from the samples. As a practical compromise, assume that a bandwidth which contains 99% of the energy of x(t) is great enough to practically reconstruct x(t) from its samples. What is the minimum required sampling rate in this case?

X( f ) = (8/3) sinc( f /3)

Trades & Technology