Technician A says that a small-hole gauge (also called a split-ball gauge) is used with a micrometer to measure small holes such as the inside diameter of a valve guide. Technician B says that a dial caliper is used to measure the inside diameter of a piston. Which technician is correct?
A) Technician A B) Technician B C) Both technicians D) Neither technician
A
You might also like to view...
What is the purpose of reference documentation?
What will be an ideal response?
What class of tools are used to set anchors in concrete or steel construction?
A. battery-powered tools B. explosive powder tools C. compressed air tools D. hydraulic tools
When tuning across the resonant frequency of a series RLC band-pass filter, which of the following is true?
A) The output voltage across the load is minimum. B) Current flow through the load is minimum. C) The impedance of the filter should be maximum at resonance. D) The impedance of the filter should be minimum at resonance.
Drawings are often supplemented with ____, symbols, and written information.
A. annotations B. notes C. references D. extensions