Brakes that drag or fail to release can be caused by a ________

A) Plugged vent port (compensating port) B) Leaking secondary cup
C) Failure of the residual pressure (check) valve D) Leaking primary cup


A

Trades & Technology

You might also like to view...

Convert the information given in the table below from the U.S. customary units to SI units.

Trades & Technology

What advantage does the 74LXX series device have over standard TTL?

A) lower voltage requirements B) reduced propagation delay C) higher propagation delay D) low power consumption

Trades & Technology

A _____ is a heat recovery and ventilation device that pulls polluted air from within the building envelope and transfers the heat by pulling fresh air into the house.

A. trombe wall B. steam-heating unit C. air-to-air heat exchanger D. diffuser

Trades & Technology

Which of the following statements is correct?

A. On a body over frame vehicle, the front panels are attached to the frame via an adjustable radiator core support. B. The front fenders should be shimmed to raise them up to the correct height to compensate for insufficient structural repair. C. The hood should be installed last when replacing the entire front sheet metal assembly. D. The rear glass is nearly always attached to the rear hatch with hinges on a hatchback model.

Trades & Technology