Relay coils and the contacts they operate are not shown in the same place on a schematic diagram because:
A) The coil and contacts are located in different places in the unit.
B) Schematic diagrams typically only show where to connect the power wiring.
C) There is not enough room to draw them in the same place.
D) Components are placed by their function in the circuit, not their actual physical location.
D
You might also like to view...
Backlash and carrier side bearing preload adjustments are made by ________.
A) Threaded adjusters or by changing shims B) Using a case spreader C) Tightening or loosening the ring gear retainer bolts D) Adding a shim behind the pinion shaft bearing
An automatic transmission or transaxle receives engine power through which part?
A. A planetary gear set B. A valve body C. An input shaft D. A torque converter
What is the secondary current in Figure 14-1 with a 50 ? load resistor and 4:1 turns ratio?
A) 4.8 A B) 1.66 A C) 600 mA D) 9.6 A
An air chuck is used to measure the amount of pressure in a tire.
Answer the following statement true (T) or false (F)