When processing the signal from an inductive pulse generator used to measure shaft rotational speed, which of the following is used to process the signal to an rpm value?
A. DC voltage
B. AC voltage
C. Amperage
D. Frequency
Answer: D
You might also like to view...
Conductor sizes are expressed in American Wire Gage (AWG) or in ____.
A. circular mils B. copper gauge units C. diameter in inches D. millimeters squared
A small car produces a maximum power output of 120 bhp at sea level. Determine the maximum power output in Kalispell, Montana, where the altitude is about 3,000 feet. Round to the nearest horsepower
What will be an ideal response?
An element of the OBD II diagnostic management system which stores engine data during a DTC set is called ________
A) Freeze frame B) Memory account C) Misfire D) Vehicle in vehicle out
The currents used with A-CAC electrodes compared to shielded metal arc welding (SMAW) electrodes of
the same size are _____. a. much lower b. much higher c. slightly higher d. slightly lower