A ____ is referred to as an instrumentation device.
A. sensor
B. transmitter
C. controller
D. final control element
E. all of the above
Answer: E
Trades & Technology
You might also like to view...
When there is a larger dent in the wheel, it must be checked for radial and lateral ____________________ before it can be used.
Fill in the blank(s) with the appropriate word(s).
Trades & Technology
Technician A says that as the clutch drive hub is replaced, the air gap should be checked at three different places. Technician B says that the air gap is not important as long as the clutch ohms are correct. Who is correct?
A) Technician A only B) Technician B only C) Both technicians A and B D) Neither technician A nor B
Trades & Technology
Lines on drawings used to indicate an area that has been cut away and shown in a section view are called _____ lines.