A cutting plane line is shown completely through the object, passing through offset features of the object. The section on the drawing is a(n) ____.
A. full section
B. half section
C. aligned section
D. removed section
E. none of the above
Answer: C
You might also like to view...
Estimating the costs and returns for a particular activity is called developing a(n) ____.
A. enterprise B. enterprise budget C. profitability D. corporation
____ are used on most fuel tanks and carburetors to permit atmospheric air pressure to enter into certain important areas within the fuel system.
a. Containment hoses b. Flow hoses c. Vent hoses d. Vapor hoses
You built a deck 12 feet by 16 feet with 4-foot wide steps. You used 6-inch deck boards for the floor. You built a railing on the outside using two 2X4s at the top and bottom with a deck board top. The spindles are spaced on 4-inch or less centers.
a. How many square feet are in the deck? b. How many deck boards are needed for the floor running the length of the deck? c. How many of what length 2X4s and deck boards are needed for the railing? d. Approximately how many spindles are needed?
Use the gas laws to find the missing value: P1 = 24 psia, V1 = 2 cu in, T1= 24° C, V2 = 1.3 cu in, T2 = 54° C find P2 to the nearer hundredth psia when necessary.
Fill in the blank(s) with the appropriate word(s).