A skin irritation caused by contact with wet cement or mortar is called cement _____.
a. rash
b. dermatosis
c. dermatitis
d. inflammation
c. dermatitis
You might also like to view...
Technician A says that a torque arm is designed to support the weight of the vehicle. Technician B says that a torque arm is designed to prevent rear axle wind up. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians A and B D) Neither technician A nor B
Some vehicles are equipped to signal the computer whenever the power steering pressures increase so the idle speed can be increased to prevent stalling during turns at low speeds. What component signals the computer?
A) Rotary Valve B) Power steering pressure switch C) Flow control valve D) Pressure relief valve
Answer the following statement(s) true (T) or false (F)
1. The modulus of rigidity is a measure of how easily a material will stretch when pulled or how well the material will shorten when pushed. 2. Concrete is stronger in tension than it is in compression. 3. The coefficient of linear expansion can be used to determine the change in the length (per original length) of a material that would occur if the temperature of the material were changed. 4. The value of heat capacity represents the amount of thermal energy required to raise the temperature of 1 kilogram mass of a material by 1°C. Materials with large heat capacity values are good at storing thermal energy. 5. The lower the viscosity value is, the more resistance the fluid offers to flow.
Solve and reduce all answers to lowest terms:3 1/8' + 3 1/4' + 3' + 5/8' =
What will be an ideal response?