From the following, select the item that makes this statement FALSE. When performing a continuity check on a cable _______
A) Not all pins are wired to the matching pin on the other end.
B) Not all pins have to be connected to a pin on the other end.
C) All pins connect one to one.
D) A 0 ohm reading means a good connection.
C
You might also like to view...
____ takes place within an organization-wide control infrastructure, which is established by the plan.
A. Strategic governance B. Strategic planning C. Strategic management D. Strategic development
A(n) __________ item is a hardware or software item that is to be modified and revised throughout its life cycle.
A. revision B. update C. change D. configuration
In an industrial control system (ICS), the operator watches some kind of monitor-the ____________________-and intervenes if necessary.
Fill in the blank(s) with the appropriate word(s).
In the figure above, which type of brush was most likely applied to the path?
What will be an ideal response?