Describe the practice for representing a sheet metal part using a flat pattern with manufacturing information extracted to a table.
What will be an ideal response?
Tables are commonly used for a variety of drafting applications, including tabular dimensioning. A table is an arrangement of rows and columns that organize data to make it easier to read. Some CADD applications allow you to extract existing model or drawing data to form a table. For example, you can create a hole table from hole features or a bend table from sheet metal bends. You can also create general tables for other applications.
You might also like to view...
Water is initially at 150°C and a pressure of 1000 kPa. The volume in the container is sloWater is initially at 150°C and a pressure of 1000 kPa. The volume in the container is slowly increased, causing the pressure to decrease, until the pressure is 80 kPa. The saturation pressure of water at 150°C is 475.8 kPa. The temperature of the water is maintained at 150°C through the process. Show the process on a P-v diagram, and describe what happens to the water during the process.wly increased, causing the pressure to decrease, until the pressure is 80 kPa. The saturation pressure of water at 150°C is 475.8 kPa. The temperature of the water is maintained at 150°C through the process. Show the process on a P-v diagram, and describe what happens to the water during the process.
What will be an ideal response?
The accompanying figure shows an ____ drawing.
A. oblique B. orthographic C. isometric D. anisometric
Which of these may be used to restore damaged threads on a bolt?
A) Tap B) Die C) Either A or B D) Neither A nor B
A blocked hydraulic system is referred to as ____.
A. deadheaded B. static head pressured C. nonfunctional D. overloaded