A diagnostic trouble code (DTC) has been set for a fault with the lateral acceleration sensor or circuit. What test could be performed to check if the sensor is working?
A) Disconnect the sensor and hold it sideways to see if the scan tool reads 1.0 G
B) Drive the vehicle in a circle to see if the scan tool reads 0.0 G
C) Disconnect the sensor and hold it sideways to see if the scan tool reads 0.0 G
D) Unplug it and see if the scan tool reads 1.0 G
A
You might also like to view...
When creating an auxiliary view of a curved or irregular surface, you should project points on the curved edges to define them in the new view. For a circular hole, usually ____ radial points are sufficient.
A. one B. two C. three D. four
Division 2 includes
A. site work B. Equipment C. Mechanical D. General Requirments
In the op amp circuit of Fig. 8.112, determine v?(t) for t > 0. Let vin = u(t) V, R? = R? = 10 k?, C? = C? = 100 ?F.
 FIGURE 1.png)
What was the first hybrid SUV?
A. Toyota Highlander B. Ford Escape C. GMC Yukon D. Chevrolet Suburban