The formula for center-to-center length of each segment of a mitered turn is _____.

a. radius times 2
b. diameter times 2
c. 2 times radius times tangent of miter
d. 2 times tangent of miter


c. 2 times radius times tangent of miter

Trades & Technology

You might also like to view...

Five basic functions must be performed in the operation of small business to move a product or service from the supplier to the consumer

Indicate whether the statement is true or false

Trades & Technology

The layer of sand in a bunker should be ____ inches deep

A) 1 to 2 B) 4 to 6 C) ?8 to 10 D) 12

Trades & Technology

Answer the following statement(s) true (T) or false (F)

1. Most alternating-current energy is generated by three-phase generators. 2. When three-phase voltage is connected to a three-phase motor, a rotating magnetic field is produced inside the motor. 3. The voltage across the line wires is called the end-to-end voltage. 4. The line current and the phase winding current are the same. 5. In a balanced three-phase circuit, the power factor is always the sine of the angle between the coil voltage and the coil current.

Trades & Technology

When compared to a port fuel injected engine, a GDI engine will have a ________ compression ratio

A) Lower B) Higher C) Interrupted D) Reversed

Trades & Technology