Before replacing a diagnosed faulty EBCM, the technician should do which of these?

A) Lock the brake pedal down
B) Replace the wheel speed sensors
C) Check the EBCM power and ground connections
D) Charge the vehicle battery


C

Trades & Technology

You might also like to view...

The NECĀ® specifies the minimum radius of conduit bends because _____.

a. installation of additional pull boxes is more efficient b. bending equipment cannot produce tighter bends c. the insulation on conductors could be damaged as it is pulled d. the internal diameter of the conduit may be increased

Trades & Technology

In modulated current transfer, why is the explosive reestablishment of the arc softer, occurring over a very short period of time??

What will be an ideal response?

Trades & Technology

A cooling system bleeder valve is used to ________

A) Control system pressure B) Remove excess coolant C) Bleed out any brake fluid that may have gotten into the cooling system D) Release air from the system when refilling

Trades & Technology

Technician A says that disc brake pads showing cracks in the lining material should be replaced. Technician B says the pads should be removed and inspected whenever there is a brake performance complaint. Which technician is correct?

A) Technician A only B) Technician B only C) Both Technicians A and B D) Neither Technician A nor B

Trades & Technology