Describe the procedure used to remove adhesive bonded nameplates with fishing line.
What will be an ideal response?
One way to remove emblems is using the fishing line method. In this technique, first, protective tape is placed around the part being removed. Then a length of high- strength plastic fishing line is cut, and the middle of the length is slipped under one corner of the emblem. The line is pulled in a seesaw method under the emblem, the adhesive is cut, and the part removed.
You might also like to view...
The subsequent problems deal with the circuit below where:R1=5k?, R2=10k?, R3=5k?, R4=10k?, R5=10k?, V1=5V, and V2=10V.
What is the voltage across R2?
A. 2/3 V B. 10/3 V C. 1/3 V D. 1/2 V E. 5/3 V
The information that is entered into the Repairs section of the RO includes ________
A) The promise time and estimate B) Customer concerns and explanation of repairs performed C) Vehicle information and milage D) Approvals of estimates and additional comments
The amount of pressure you should apply to a bushing in an arbor press would be:
A) Just the amount needed to push it through the bore and when slight additional pressure is felt, stop pressing B) About 5 tons C) Just the amount needed to push it through the bore and then considerable more force applied to make sure it is seated D) Between 10 and 30 tons
What will a standard oscilloscope display of the transmitted AM signal indicate?
A. Modulating voltage B. Gross deficiencies C. Intelligence frequency rate D. Available energy