The C language was partly developed to resolve the more lengthy requirements of assembly language.
Answer the following statement true (T) or false (F)
True
You might also like to view...
When fabricating pre-assembled mats, the perimeter joints should be tied at 100 percent, and the interior intersections at _____.
a. 20 percent b. 25 to 50 percent c. 75 to 80 percent d. 100 percent
Answer the following statement(s) true (T) or false (F)
1.A separate equipment grounding conductor must always be installed in runs of Type ENT. 2.Section 300.9 states that when installing conduits above grade in a wet location (like outdoors on the side of a house), the interior of the conduit is considered a wet location. 3.Electricians often refer to Type RMC as “heavy wall” conduit. 4.Although they are not commonly used, threadless couplings and connectors can be used with Type RMC. 5.It is OK to use a metal fish tape to pull or push conductors in a raceway that is connected to an energized loadcenter.
In order to distinguish structural members within a job, it is common practice to assign ____ from different series, e.g., columns assigned in the 100 series and beams in the 200 series.
A. individual member numbers B. fabrication ID numbers C. mark numbers D. jigsaw numbers
Which tool listed is a brand name?
A) Side cutters B) Locking pliers C) Monkey wrench D) Vise Grips