When calculating the power of a pure resistive load, the voltage and current are in phase with each other and the power factor is _____.
A. one
B. two
C. three
D. four
Answer: A
You might also like to view...
Answer the following statement(s) true (T) or false (F)
1. The National Standard Plumbing Code requires the water distribution system to be sized for a maximum velocity of 12 feet per second at the design flow rate. 2. Curb valves are located at the termination of the water service and provide isolation safety and maintenance capabilities for a structure. 3. Codes state that the maximum allowable pressure in a structure shall be limited to 80 psi under static conditions (no flow). 4. Riser valves are required when water lines pass through more than one floor. 5. Gray water systems shall never be connected to the water distribution system regardless of the degree of treatment.
When making a current measurement with a VOM meter, you should ________
A) create an open in the circuit and place the meter probes so that the meter is in series with the load B) place the meter probes across the load C) turn off all power to the circuit during the current reading so you don't get shocked
Motors that sit on resilient rubber rings typically use which type of mounting?
A) Cradle mount B) Flange mount C) Stud mount D) Belly band
The address bus, along with the data and control busses, is bidirectional
Indicate whether the statement is true or false