Technician A says that all bleeder valves must be located at the highest part of the caliper or wheel cylinder. Technician B says that all bleeder valves have a hole in the center. Which technician is correct?

A) Technician A only B) Technician B only C) Both technicians D) Neither technician


C

Trades & Technology

You might also like to view...

Answer the following statement(s) true (T) or false (F)

1. Regardless of material boundary indicates that a datum feature simulator is adjustable (or movable) from MMB toward LMB until it makes maximum contact with the extremities of the datum feature(s). 2. Per Rule #2, MMB is the default condition referenced by a size datum feature. 3. Datum feature selection and datum feature reference are directly related to how a part functions in its assembly. 4. Where a feature of size is referenced at RMB, three conditions exist. 5. In the case where a surface is the primary datum feature, a diameter is the secondary datum feature at RMB, and a width is the tertiary datum feature at RMB, the datum reference frame consists of a plane and an axis with two planes passing through it.

Trades & Technology

Discuss how to use manure

What will be an ideal response?

Trades & Technology

A compressor that uses an impeller to throw refrigerant from the center outward is a:

A) Centrifugal compressor. B) Rotary compressor. C) Scroll compressor. D) Screw compressor.

Trades & Technology

The heat sink for a heat pump is:

A) The cool medium that the evaporator draws heat out of. B) Always water. C) The warm medium that the condenser rejects heat into. D) Always air.

Trades & Technology