Horizontal-circle scales on a transit that are marked from 0 to 360 degrees are usually numbered each _____
a. 5 degrees
b. 10 degrees
c. 45 degrees
d. 60 degrees
b
You might also like to view...
Technician A says a fixed geometry turbocharger requires pressure relief because it operates over a wide rpm band. Technician B says a wastegate is commonly used to control the speed of the turbine in automobile engines. Who is correct?
A. Technician A B. Technician B C. Both technicians D. Neither technician
?Which of the following would not be a NDT type test of a weld.
A. ?tensile B. ?visual C. ?leak D. ?penetrant
When two views are needed, they usually include:
A. Front and right-side or front and top views B. Right-side and left-side views C. Top and bottom views D. Left-side and bottom views
How are mechanical interlocks shown in a schematic diagram?
What will be an ideal response?