End grinding of the band ends before welding should be done:
A) On each end separately B) On the pedestal grinder
C) With the teeth opposed D) With the teeth on the same side
C
You might also like to view...
Some laser cutting equipment can make cuts that are within ± a hundred thousandths of an inch, which is as accurate as some rough machining operations.
Answer the following statement true (T) or false (F)
The ____ system is designed to enhance night-time safety by turning the headlight beams to follow the direction of the road as the vehicle enters a turn.
A. adaptive headlight B. headlight leveling C. automatic dimming D. night vision
Technician A says the parking brake cable adjustment should be performed before adjusting the rear brakes. Technician B says the parking brake cable should allow for about 15 "clicks" before the parking brake holds. Which technician is correct?
A) Technician A only B) Technician B only C) Both Technicians A and B D) Neither Technician A nor B
Which of these wires is MOST likely used for starter motor high current circuits?
A) 20 ga. B) 14 ga. C) 18 ga. D) 0 ga.