?An advantage of a(n) _____ contract is that the contractor does not have to allow for unforeseen problems.

A. ?cost-plus
B. ?lump-sum
C. ?fixed-sum
D. ?presale


Answer: A

Trades & Technology

You might also like to view...

Control limits are best described as:

a. the highest point established as the top specification on a control chart. UCL X-bar = Average X-bar + (A2 X Average R). b. boundaries that tell you if the process is in control. c. a cause of variation or special cause. d. the lowest point established as the bottom specification on a control chart. LCL X-bar = Average X-bar – (A2 X Average R).

Trades & Technology

Soap is a commonly used surfactant

Indicate whether the statement is true or false

Trades & Technology

PROBLEM 3.7 The solid spindle AB is made of a steel with an allowable shearing stress of 12 ksi, and sleeve CD is made of a brass with an allowable shearing stress of 7 ksi. Determine (a) the largest torque T that can be applied at A if the allowable shearing stress is not to be exceeded in sleeve CD, (b) the corresponding required value of the diameter of spindle AB.

Trades & Technology

Refer to Appendix Table 23 in your textbook. An F8/h7 symbol would be used to specify a ____ fit.

A. close running B. sliding C. loose running D. force

Trades & Technology