An object is sketched in isometric by positioning it so that the part seems to rest on ____.
A. the front face
B. one corner
C. the back face
D. its top
Answer: B
You might also like to view...
Fresh air is allowed to enter the charcoal canister:
A. When the PCM purges the canister B. When the PCM performs a leak test C. During the weak vacuum test D. When a rich air/fuel mixture is needed
Technician A says the signals from the transmission fluid temperature sensor affect the application of the converter clutch. Technician B says at excessive fluid temperature the TCm will command the clutch to unlock. Who is correct?
A. A only B. B only C. Both A and B D. Neither A nor B
The duct sizes are shown on plans as 30" x 18" for the supply ductwork is ______________.
A. 30" wide & 18" long B. 18" long & 30" wide C. 30" + 18" D. 48"
A technician pushes a 50 lb box 4 feet in 2 seconds. The rate of work is:
A) 200 ft lbs/2 s= 100 ft lbs/s. B) 4 ft lbs. C) 50 lbs × 4 feet = 200 ft lbs. D) 50 pounds.